by Cornell University Library

Before actually marking these though, you must at least check your straight cut tiles to determine whether they match well or not. A number of these floor tiles may need to be cut in two directions when projecting from your foundation floor tile or chalk line, and still the tile breaker will achieve this job so long as it’s a straight line that you wish to obtain.
The corner of a room as an example, you’ll have to chop a twelve” inch floor tile in 0.5 to urge a 6″ tile that will match your projection properly. But, when meeting with another wall returning in perpendicular to your dry laying tile projection, like what’s found within the corner of a space, then you’ll need to chop the tip off the final tile in order to shorten its length.
To cut this tile, the ceramic tile breaker is right still, but continuously remember to incorporate in your measurements the subtraction of one/8″ in. from the overall size to make sure that you have that necessary sealing gap between the wall and the floor tile. What you don’t wish is the tile directly in grips with the wall. Another issue to contemplate is your grout spacing between the adjacent tiles, therefore no matter sized grout lines you propose to apply, subtract accordingly.
Next, you will wish to check the tile against its position once it is cut. With grout spacers in place for a dry laying trial run, build certain that the gap between the wall and the tile is near enough to 1/eight” in. as possible. If the tile is undersized terribly slightly, this might be nothing to stress concerning, as depending on the thickness of your baseboards you propose to put in, these can actually hide the gap.
If the tile is oversized but, then you have got 2 options. Either cut another contemporary tile piece again but slightly smaller than the first to allow for the gap to be present, or trim down the edge of the existing cut tile piece using a wet tile saw. The tile breaker can never be in a position to chop something much less that 1″ wide even for a seasoned professional tiler, or a pair of” wide if you are a novice at using the breaker.
Another tip when fitting cut tiles is to always keep the finished factory edge to the interior of the floor. For best results in a finished floor, the rougher cut fringe of any tile ought to invariably be placed next to the walls, as this again can be hidden by your baseboards.
When also creating straight cuts in floor tiles that are similar to at least one another and are following a straight line, like for example, against the length of a wall or a fastened furnishing such as a toilet sink unit, there’s an straightforward approach to avoid making excessive measurements. Merely by measuring and cutting the primary floor tile, you’ll then mirror the dimensions onto every subsequent tile.
Simply bear in mind though to stay the rough edge to the vertical face of the wall or obstacle, which might require in some instances by flipping the tile one hundred eighty degrees in your markings. Given time, you will soon pick up time-saving techniques of your own once your confidence has increased when floor tiling, therefore primarily simply work with the method that suits you best.