A DIY checklist for putting in a pedestal sink

The installation of a completely new pedestal sink might be a considerable work load, but the ordinary do-it-yourselfer is capable of having great outcomes in less than a day without busting your budget.

The first step in almost any bathroom remodels and renovations project, regardless of size, is going to be planning. Throughout this period, bear in mind the floor space you will get is a tradeoff because of the decrease in storage space you now possess beneath the sink.

Plan on doing a certain amount of wall repairs purely because, as soon as you take out the old cabinet, there are usually defects plus the wall in all probability wasn’t painted before the sink base was initially installed. At the same time, you could be putting in new floor covering mainly because it most likely is not finished and / or might have damage under the present cabinet.

Before you do away with the previous vanity and sink, you need to pick out the sink you like and notice just how the supply lines and also drain is going to hookup on your existing plumbing. This is really important simply because the drain is concealed in back of the pedestal and the water supply lines could be ” totally exposed “, although they really need to be even and as near to the bowl as possible in order to look good. Some designs can mask all of the plumbing far better than others.

When your drains along with water supply lines are in the ideal locations, your task just got much easier. Although if the drain and / or supply lines will be off-center from the place you choose to place the sink, it would be necessary to move your pipes.

If you are living in a slightly older house with cast-iron drains and also galvanized plumbing, it can be complicated.

Any time you don’t feel comfortable accomplishing this part of the job; bring in a qualified professional, mainly because a water problem can cause a number of extremely major plus possible very expensive issues. If you choose to do the project all by yourself, remove a little of the wall to show the piping. Always incorporate extreme caution, considering that within the wall happen to be water pipes and maybe electric wires that you don’t need to damage.

Just turn the water off and then shift the plumbing within the walls to match the instruction diagram that is provided with the sink. Add a little bit of lumber for you to secure your sink on the wall at the accurate height, keeping in mind any floor density that may alter should you add or remove tile.

If you are fortunate and the plumbing will function with its existing location, place your sink in place and target the locations on your wall for your sink anchoring screws. Move the sink away and verify if you have framing in these locations. If not, get rid of a little section of your wall, put in some blocking to obtain support and then mend the wall.

It is actually much simpler to add the faucet and water supply lines on your sink before you secure your sink in place. In the event you are working with a one-piece sink, you are forced to perform in very limited spots. A large number of pedestals are a two-piece style, so you can set the bottom part in place, and then level along with secure the sink on the wall, being careful not to over-tighten the screws.

Now you can add a short piece of wood below the sink bowl which will support it, and take away the bottom. You now possess good accessibility to fix the plumbing. Look for leaking, put the bottom part back into place as well as secure according to the instructions that was included with the sink. Some pedestal bases screw in your floor yet others use adhesives. Take joy in your brand new sink.